Texas Instruments ADS131M04 4-Channel Analog-to-Digital Converter
Texas Instruments ADS131M04 4-Channel Analog-to-Digital Converter (ADC) is a 24-bit delta-sigma (ΔΣ) ADC that offers a wide dynamic range, low power, and energy-measurement-specific features. This makes these devices excellent for energy metering, power metrology, and circuit breaker applications. The ADC inputs can be directly interfaced to a resistor-divider network or a power transformer to measure voltage or to a current transformer or a Rogowski coil to measure current.
Features
4 simultaneously sampling differential inputsProgrammable data rate up to 32kSPSProgrammable gain up to 128Noise performance102dB dynamic range at gain = 1, 4kSPS80dB dynamic range at gain = 64, 4kSPSTotal harmonic distortion: –100dBHigh-impedance inputs for direct sensor connection300kΩ input impedance for gains of 1, 2, and 41MΩ input impedance for gains of 8, 16, 32, and 64Programmable channel-to-channel phase delay calibration244ns resolution, 8.192MHz fCLKINCurrent detect mode allow for super low power tamper detection
Applications
Electricity meters: commercial and residentialCircuit breakers
Texas instruments Newest
Texas Instruments LM5155EVM-FLY Controller Evaluation Module (EVM) showcases the features and performance of the LM5155 as a wide input non-synchronous flyback controller.
Date: 2019-09-26Texas Instruments TPS560430QEVM Converter Evaluation Module (EVM) is a fully assembled and tested circuit for evaluating the TPS560430-Q1 series step-down converters.
Date: 2019-09-26Texas Instruments TPS62840-1xxxEVM5x Converter Evaluation Modules (EVMs) facilitates the evaluation of the TPS6284x family of 750mA, step-down converters with 60nA IQ.
Date: 2019-09-25Texas Instruments TPS6284x High-Efficiency Step-Down Converters come with ultra-low operating quiescent current of typically 60nA.
Date: 2019-09-25Texas Instruments TPS92682EVM-070 Evaluation Module (EVM) features a two-channel, constant current boost, and boost-to-battery regulator based on the TPS92682 dual-channel controller with SPI interface device.
Date: 2019-09-25Texas Instruments TPS92682EVM-069 Evaluation Module (EVM) features a two-phase, constant voltage boost regulator based on the TPS92682 dual-channel controller with SPI interface.
Date: 2019-09-25Texas Instruments TPS92682-Q1 Dual-Channel Peak Current-Mode Controller is programmable to operate in constant-voltage (CV) or constant-current (CC) modes.
Date: 2019-09-25Texas Instruments PGA460PSM-EVM Proximity-Sensing Evaluation Module (EVM) is a small-form-factor solution showcasing double-sided printed circuit board (PCB) spacing and the supporting component requirements for the PGA460.
Date: 2019-09-24
选择你的位置